FANTASTIC M

Contact Cure

Orthodontic Adhesive

Kit Contains

Activator -10 g

Adhesive-25 g (5 syringes)

Enamel Conditioner-12 g

Accessories & Instructions

INSTRUCTIONS FOR USE

 1. Prophylaxis. Thoroughly clean teeth to be bonded with an oil-and fluoride-free prophylaxis paste. Take care not to irritate the gingival tissue as this may cause bleeding and contamination of the bonding area.

2. Rinse and Dry. Rinse thoroughly with water, isolate the teeth, and dry.

3. Etch. Dispense one or two drops of Enamel Conditioner onto mixing pad, and apply with a brush or foam pellet applicator onto teeth to be bonded. Etch for 1 to 1 1/2 minutes. Do not allow acid to contact soft tissue or inter-proximal areas.

4. Rinse and Dry. Flush teeth thoroughly with water to remove all traces of acid. Re-isolate and completely air dry teeth to be bonded. Do not allow patient to rinse or permit etched enamel to contact saliva. After drying, etched areas should appear chalky white; in some instances re-etching is required to achieve this effect.

5. Application of the Primer: Apply a thin coat of Primer to the base of bracket and prepared tooth surface with a brush.

6. Application of Adhesive. Apply a small amount of Adhesive paste directly on bracket base.

7. Bracket Placement. Press bracket with a slight rotation action on primed tooth surface. Correct the position of the bracket on the tooth no later than 20 seconds after bracket placement.

8. Wire Placement. Arch wires may be place just 4 minutes after last bracket is bonded.

CAUTION: Enamel Conditioner contains phosphoric acid. Avoid contact with skin, eyes, or soft tissue. In case of contact, flush with water. Get medical attention if eyes are affected.

Adhesive and Activator: Avoid prolonged or repeated contact with skin. Wash with soap and water after contact. If skin irritation occurs, discontinue use. If plastic brackets are used, follow bracket manufacturer’s recommendation for conditioning of bracket bases surface before bonding. In most instances, the use of Dent Zar’s plastic bracket primer will assure good bond to the bracket base.

 HELPFUL HINTS

 1. Rebonding, if necessary, requires removal of all remaining adhesive from tooth. Repeat the entire bonding procedure as outlined above.

2. If longer than 20 seconds adjustment time is required, the paste should be taken out of the refrigerator just prior to use.

 STORAGE

 The material should be stored in a cool place at temperatures not exceeding 75°F (24°C). Under such conditions, the shelf life is in excess of one year. Routine refrigeration will extend shelf life to over two years. Do not freeze.

Dent Zar Inc.

19643 Trull Brook Drive

Tarzana, Ca 91356

U.S.A.

Tel: 800-444-1241, Outside U.S. 323-4665-3621

Web Site: www.dentzar.com E-mail: dentzar@yahoo.com