Instructions                                                      Made In U.S.A

OLYMPIAN-M

Temporary Crown and Bridge Cement

Auto-Mix System

INDICATIONS FOR USE

Temporary cementation of crowns, bridges and splints.

Retention of temporary crowns, sealing dressing in teeth during root canal therapy procedures.

Trial cementation of permanent restorations prior to final insertion.

Testing of interproximal contacts prior to final placement.

KIT CONTAINS

20 g of Temporary Cement in Auto-Mix Cartridges.

Accessories & Instructions.

OUTSTANDING FEATURES OF THE MATERIAL

Excellent handling characteristics.

Good reproducibility of working time.

X-ray opacity.

Biocompatible

Negligible solubility.

Low film thickness.

Well-balanced adhesive properties provide good prosthesis retention

while allowing for trouble-free removal.

Sufficient flow of the cement facilitates complete seating of the restoration.

Resistance to oral environment and good mechanical strength assure excellent

performance of Olympian-M cement.

Compatible with all commercially available cements.

Eugenol free.

APPLICATION

In case of direct pulp exposure, use a calcium hydroxide-type base to cap the pulp.

It is imperative to disinfect and dry the preparation before cementing due to the fact that all synthetic cements are hydrophobic by nature.

The presence of moisture may result in inferior retention, possibility of microbial contamination, and post-operative sensitivity. Unless counter-indicated for the reason of proximity to the pulp, the removal of the smear layer prior to cementing will further contribute to the enhanced retention and greater integrity of the tooth-cement interface.

CEMENTING

1.

Remove the closure cap from the cartridge (Do Not Re-Use The Cap!).  Install the mixing tip onto the cartridge and extrude the needed amount of material. After Each Use Leave The Used Mixing Tip In Place To Seal The Cartridge. The initial extrusion from mixing tip (about the size of a pea should be discarded.)  The following mixture will be perfect. This must be done with each new mixture

2.

Spread a thin layer of cement inside crown and then set crown firmly.

  

Olympian-M has 90 seconds working time.

3.

Trim the excess material 2 minutes after seating.

4.

Final set is 2.5 minutes after seating.

5.

To remove temporarily cemented crowns or bridges, use a crown remover and dislodg

 

with sharp taps. The crown should release quickly and cleanly.

6.

If cementing crowns, remove old cement from inside of the crown and dry crowm

 

thoroughly.

7.

Where less bond strength is desired add petrolatum (Vaseline), or mineral oi

   

After 1 minute, trim excess.

8.

Important: Olympian-M is intended to be used for less than 30 days.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 STORAGE

Do not store or expose kit to temperatures over 72ºF (22ºC). If stored refrigerated remove, 20 minutes prior to use.

Use only at room temperature (refrigerated material is more viscous and cures more slowly).

Dent Zar, Inc.

19643 Trull Brook Dr.

Tarzana, CA 91356

U.S.A.

Toll Free: 800-444-1241, Outside U.S. 323-465-3621

Fax: 323-465-2994, E-mail: dentzar@yahoo.com., Web Site: www.dentzar.com.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Back To Olympian M Auto-Mix System