Instructions                                                 Made In U.S.A

OLYMPIAN-M

Temporary Crown and Bridge Cement

INDICATIONS FOR USE

Temporary cementation of crowns, bridges and splints.

Retention of temporary crowns, sealing dressing in teeth during root canal therapy procedures.

Trial cementation of permanent restorations prior to final insertion.

Testing of interproximal contacts prior to final placement

KIT CONTAINS

14 g -Temporary Cement Part A

14 g -Temporary Cement Part B

Accessories & Instructions

OUTSTANDING FEATURES OF THE MATERIAL

• Excellent handling characteristics.

• Good reproducibility of working time.

• X-ray opacity.

• Biocompatible.

• Negligible solubility.

• Low film thickness.

• Well-balanced adhesive properties provide good prosthesis retention while allowing for trouble-free removal.

• Sufficient flow of the cement facilitates complete seating of the restoration.

• Resistance to oral environment and good mechanical strength assure excellent performance of Olympian-M

  cement.

• Compatible with all commercially available cements.

• Eugenol free.

APPLICATION

In case of direct pulp exposure, use a calcium hydroxide-type base to cap the pulp.

It is imperative to disinfect and dry the preparation before cementing due to the fact that all synthetic cements are hydrophobic by nature.

The presence of moisture may result in inferior retention, possibility of microbial contamination, and post-operative sensitivity. Unless counter-indicated for the reason of proximity to the pulp, the removal of the smear layer prior to cementing will further contribute to the enhanced retention and greater integrity of the tooth-cement interface.

CEMENTING

1. Place about equal amounts of Paste A and B on a mixing pad.

2. Spatulate the two pastes together for approximately 20 seconds. Make certain the two

    pastes are well blended with no residual streaks of each paste evident in the mixture.

3. Spread a thin layer of cement inside crown and then set crown firmly. Olympian-M has 90 seconds  working

    time.

4. Trim the excess material 2 minutes after seating.

5. Final set is 2.5 minutes after seating.

6. To remove temporarily cemented crowns or bridges, use a crown remover and dislodge

    with sharp taps. The crown should release quickly and cleanly.

7. If cementing crowns, remove old cement from inside of the crown and dry crown

    thoroughly.

8. Where less bond strength is desired add petrolatum (Vaseline), or mineral oil.

    After 1 minute, trim excess.

9. Important: Olympian-M is intended to be used for less than 30 days.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

STORAGE

Do not store or expose kit to temperatures over 72ēF (22ēC). If stored refrigerated remove, 20 minutes prior to use.

Use only at room temperature (refrigerated material is more viscous and cures more slowly).

Dent Zar, Inc.

19643 Trull Brook Dr.

Tarzana, CA 91356

U.S.A.

Toll Free: 800-444-1241, Outside U.S. 323-465-3621

Fax: 323-465-2994, E-mail: dentzar@yahoo.com., Web Site: www.dentzar.com.

 

 

 

 

 

 

 

 

 

 

 

 

Back To Olympian M Syr.System